Instructions / Assembly
5
Assemble Fence (Horizontal Board Installation):
a. On rst post insert the rail into the post channel
and line up the holes of bottom rail and bottom
of post. Make sure the open pocket in the rail
is facing up (Fig. 11). Insert pin (from post kit).
b. On second post, insert the opposite end of the
bottom rail into place, align holes, and insert pin.
c. Snap adapter strips into post channels on both
posts (Fig. 12).
d. Line up holes in top rail and top of post, and
insert rail into the post channels of both posts.
Make sure the open rail pocket in the rail is
facing down. Insert pin. This is to temporarily
hold the assembly together while a few boards
are added (Fig. 13).
e. Begin inserting boards working up from the
bottom. The rst board should t tightly into
the bottom rail. Continue until you can no
longer insert boards at an angle (Fig. 14).
f. Remove top rail and slide in the remainder of
the boards, taking care not to spread the posts
outward.
g. Place top rail back onto panel. Line up holes
in top rail and top of post and insert rail into
the post channel. Make sure the open pocket
in the rail is facing down (Fig. 15). Insert pin.
Repeat for opposite side.
h. Snap post cover (from post kit) into place by
holding cover approximately 6" from top of
post. Hook one side of the cover and push
down to snap the other side. Slide the cover
down the post to hide the pins (Fig. 16). Repeat
for other post.
i. Install post cap (from post kit) to top of post.
Use a soft rubber mallet, if necessary to obtain
a rm t (Fig. 17). Repeat for other post.
NOTE:
“Top” and “Bottom” rails are the same.
Fig. 11
Fig. 12
Fig. 13
Fig. 14
Fig. 15
Fig. 17
Fig. 16
Hook
Hook
Hook &
Hook &
Snap Snap
Post Cover
Post Cover
Post
Channel
Open Pocket