Instructions / Assembly

Assemble Fence (Vertical Board Installation):

a. On  rst post insert the rail into the post channel

and line up the holes of bottom rail and bottom

of post. Make sure the open pocket in the rail

is facing up (Fig. 5). Insert pin (from post kit).

b. On second post, insert the opposite end of the

bottom rail into place, align holes, and insert pin.

c. Snap adapter strips into post channels on both

posts (Fig. 6).

d. Begin inserting boards, starting on the outside

of both posts working your way towards the

center (Fig. 7). Be sure tongue and grooves of

boards are aligned in the proper directions.

e. Line up holes in top rail and top of post and

insert rail into the post channel. Make sure

the open pocket in the rail is facing down.

Insert pin. Repeat for opposite side (Fig. 8).

f. Snap post cover (from post kit) into place by

holding cover approximately 6" from top of

post. Hook one side of the cover and push

down to snap the other side. Slide the cover

down the post to hide the pins (Fig. 9). Repeat

for other post.

g. Install post cap (from post kit) to top of post.

Use a soft rubber mallet, if necessary to obtain

a  rm  t (Fig. 10). Repeat for other post.

NOTE:

“Top” and “Bottom” rails are the same.

Fig. 5

Fig. 6

Fig. 7

Fig. 8

Fig. 9

Fig. 10

Hook

Hook &

Snap Snap

Post Cover

Post

Channel

Open Pocket