Installation Guide

Post Installation

Use a rubber mallet to gently drive the post tops onto

the posts (sold separately). Be careful not to damage the

post top (Fig. 3).

Fig. 3

Layout Installation:

• Establish your fence line by staking out the areas you

wish to enclose. Locate each point in which you will

need an end, corner or gate post and mark it with a

stake (Fig. 1).

• For 6' sections using 2" posts: measure 72

⁄

⁄4⁄

" from

the center of an end point and mark with stake (Fig. 2).

NOTE:

• Installing on sloped terrain will reduce distance

between posts.

• If you are left with a space less than a full panel, the

panel can be cut down to  t the space by using a

hacksaw. “Notch” the cut ends of the horizontal rails

so they will sit inside of post.

• Attach string to each stake to provide straight guide

lines.

• Plan gate placement, opening and hardware

clearance before installing fencing.

Fig. 1

Fig. 2

For 6' sections using

2" posts

⁄

⁄4⁄