User guide

MFT-2700 Multi-Funtional Trainer

Weight stack label and lubrication instructions

1. Wipe front surface of weight stack with rubbing alcohol and wipe dry.

2. Peel o back sheet (adhesive side) from label (#61) and make sure that the label remains

attached to the application tape.

3. Line up left edge of label sheet with outside edge of weight holes.

4. Line up the  rst label to hole on top plate.

5. Make sure label is straight and slowly press into place.

6. Gently remove application tape and rub each label  rmly against the weight stack.

7. Allow labels to stand for 2 days to allow adhesive to cure fully.

8. Open the lube package provided and apply a thin  lm of lubricant around the  rst 3 inches

of the guide rods above the top plate.

9. After the cables are installed, do a set of reps to spread the lubricant thoroughly.

Step 6

NOTE:

1. TOP PLATE LABEL GOES ON HOLE OFF CENTER AS

SHOWN. LABEL WILL COVER HOLE ON CENTER.