Installation & Assembly

First, use

This refrigerator is widely used in aquarium refrigeration, cooling equipment, laser cooling,

Liquid cooling and other industries.

Second, product features

a, electronic refrigeration series, novel style, small and exquisite:

b. Using high-quality semiconductor refrigeration film, energy efficient.

c. Adopt microcomputer intelligent temperature control, no noise, environmental protection and

no pollution.

Third, technical parameters

Voltage: AC110V/50-60Hz

Power: 200W

Temperature setting range: 1-30'C

Cooling capacity: 120W

Applicable water pipe: water pipe with inner diameter of 8mm

Suitable for water flow: 1-3L/min

Suitable for lift: 3m or less

Power cord length: 1.5m, 3 feet flat plug

Temperature control probe line length, 2m

Dimensions: 30*14*21.5cm

PAGE 1
First, use This refrigerator is widely used in aquarium refrigeration, cooling equipment, laser cooling, Liquid cooling and other industries. Second, product features a, electronic refrigeration series, novel style, small and exquisite: b. Using high-quality semiconductor refrigeration film, energy efficient. c. Adopt microcomputer intelligent temperature control, no noise, environmental protection and no pollution.
PAGE 2
installation steps: a. Take out the refrigerator and put it on the table. The side with several temperature is the front. The inner diameter of the inlet and outlet pipes is Bmm hose connection. The pump can be installed horizontally and vertically when using the aquarium filter pump or the external water pump. If the ball is installed straight, the pump head should be facing down. b. Take out the temperature probe and put it into the liquid that needs to be cooled. Plug in the power. C.
PAGE 3
6, the temperature setting, press Set Jian (set the shutdown temperature) " ▲" Add the temperature or "▼" cooling button to adjust to the appropriate temperature. (Press the Ret button after setting or automatically return to the current temperature after about 10 seconds) 7. Press and hold the Set button to display the F1 hysteresis code (stop temperature plus hysteresis) The temperature is equal to the starting temperature.