Assembly Instructions
KEY:
T = top
U = upper
L = lower
SG = seed guard
cage assembly instructions
cage: 46"L × 36"W × 78¼"H
interior: 46"L × 36"W × 63"H
wire gauge: 9 & 9
wire spacing: ⅜"
read this!
• Enlist A Friend: This is a large cage and requires two people
to assemble.
parts
6
a
THIS STAGE REQUIRES TWO PEOPLE.
Center top (T1) roof panel fits into channels
at the very top of front upper (U1) and
back upper (U2) panels. Attach with screws
at the four bottom corners.
6
b
Side top (T2) roof panels are interchangeable.
Three hooks along top bar of (T2) roof panels
link into handles along lower bar of the (T1) panel.
Three vertical wires on (U3) and (U4) panels extend
above the upper horizontal wire. Align wires with
corresponding holes along bottom rail of (T2) panel.
Attach (T2) panels with screws in lower corners.
7 Add front door (C). Female sleeves on
the door slide down over male posts.
8 THIS STAGE REQUIRES TWO PEOPLE.
Front and back seed guard (SG1) panels have three
metal “L” tabs along lower bottom edge. Hook tabs
into sleeves along lower rail on front lower and back
lower (L1 & L2) panels.
→ Use the short hex screw & nut pairs.
While first person holds side seed guard (SG2) panel
in place, second person aligns holes in corners, and
secures front and side panels with screw & nut pairs.
→ Your cage is now fully assembled!
LEFT SIDE
FRONT BACK
RIGHT SIDE
GRILLE
DRAWER
SEED GUARD
U3
L3
U4
L4
A
C
B
U1
L1
U2
L2
T1 T2T2
{22} hex head screws
{ 8 } short hex head
screw & nut pairs for
seed guard
touch-up paint
& brush included
{ 1 } allen wrench
{ 4 } rolling casters
{ 3 } cup hangers
{ 3 } stainless steel cups
{ 1 } wood dowel perch
SG1
SG1
SG2SG2
T1
T2
T2
C
SG1 SG2
Macaw Cage
Review these instructions thoroughly before attempting to assemble
cage. If you still require assistance, please contact CustomerService
Made in China
• Count Hardware: If any screws are missing, please contact
Customer Service.
• Review All Parts: Parts may become bent during shipping;
this is common. In most cases, pieces may be straightened with
needle nose pliers. For seriously damaged parts, please contact
Customer Service.
• Tools: An allen wrench is included. You may use your own hand
tool with an allen wrench bit. We
DO NOT recommend power drills!
Parts can be over-tightened and damaged/stripped. We are not
responsible for this type of damage.