Assembly Instructions

SG4
SG3
KEY:
L = Left panels
B = Back panels
C = Center (Roof) panels
F = Front panels
R = Right panels
parts
LEFT SIDE
RIGHT SIDE
BACK
FRONT
GRILLETRAY
DOOR
SEED GUARDS
L2
L1
R2
R1
F2
F1
B2
B1
G
T
C3 C2
C1
{20} long hex head screws
{ 8 } short hex head
screw & nut pairs for
seed guard
{ 1 } allen wrench
{ 4 } rolling casters
{ 1 } wood dowel perch
{ 3 } cup hangers &
stainless steel cups
SG3
SG2
SG1
SG4
cage assembly instructions
getting started!
READ THESE NOTES FIRST:
• Enlist A Friend: This is a large cage and may require two people to
assemble for best results. You may wish to enlist a friend to help.
• Count Hardware & Review All Parts: There are usually surplus
screws.
Review these instructions thoroughly before assembling the cage.
5
a
Install the components:
Install the Perch — Perch extends from left side panel
to right side panel, and installs on a horizontal wire (see
fig.5-1 ).
Install the Cup Holders and Cups — Insert the cup
holders into the cup doors panel, and insert cups into
the holders (see fig.5-2 ). Perch cups are “locked” in
place once the door is closed, and cannot be removed
or tipped by your pet.
5
b
Install the Front Door — Holding the door in the wide-open
position, align the posts along the vertical frame rail of
the door with the sleeves along the vertical frame rail of
the front upper and lower panels (see fig.5-3 ). Slip the door
into place.
Add the Grille & Tray — Rotate the windbell lock out of the
way and slide the removable grille (G) into the top channel
tracks and the tray (T) into the bottom channel tracks.
6Assemble the seed guards:
Front & back side seed guards (SG2) & (SG3) are inter-
changeable and have tabs which fit into sleeves
protruding from lower frame rails along
the front and back lower panels.
To make assembly easier, pre-assemble
(upside-down) the SG1/SG2 pair and the
SG4/SG3 pair as specified (see fig.6-1).
Slip the right side/front (SG1/SG2) seed guard pair
into place and have your assistant hold them. Have the short
hex screw/nut pairs and the allen wrench close-by. Slip the
left side/back (SG4/SG3) pair into place. Align the holes at
the front left (SG4 + SG2) corner and secure guards together
with screw & nut pairs as illustrated. Finish with the back
right (SG1 + SG3) corner.
✩
Your cage is now fully assembled!
Made in China
G
(fig.5-1 )
(fig.5-2)
(fig.5-3)
(fig.6-1)
SG2
SG3
SG4
SG1
SG2 SG1
T
• Tools: You will only need an allen wrench (included). You may find
using your own hand-held hand tool with allen wrench bit of benefit.
If you use your own tools, please note: We do not
recommend
power tools. Screws can be over-tightened and partsmay
be damagedor stripped. We are not responsible
for this type of damage.
Cage
exterior: 46"L × 36"W × 78¼"H
w/seed guards: 54¼"L × 44⅜"W
interior: 45⅜"L × 35⅜"W × 63½"H
wire: [gauge] 9 & 9 [spacing] 1⅜"