Installation & Assembly

ManualsBrandsTucker Murphy Pet ManualsAll Bird CagesThea 53'' Steel Flat Top Flight Cage with Wheels

read first REVIEW BEFORE ASSEMBLY

• TOOLS: Allen wrench (included). Needle nose

pliers (not included) will be useful. If power

tools are used, Prevue is not responsible

for damage caused by misuse.

• Two-person assembly for best results.

To assemble the BASE,

you will need these pieces:

To assemble the SIDES,

you will need these pieces:

×4

Flip assembled unit over

and fully insert casters into

frame legs.

Attach the storage shelf to the leg

frames to create the base. Back

ends of leg frames have a backstop

tab at the track ends (fig.1-1).

[ FIG. 1-1]

Stack the side panels in place

on the base. For correct assembly,

note these details:

• top side panel: has a finished

corner (fig. 2-1).

• bottom side panel: top horizontal

surface has small holes near the

center and open-frame corners

(fig 2-2), to align with posts and

wires from the top side panel

(fig 2-3).

• nest doors swing out

Notes: Have an assistant holding

side panels for best results.

Straighten extended wires or remove

hole slugs with needle nose pliers.

[ FIG. 2-1]

[ FIG. 2-2]

[ FIG. 2-3]

Cage

Summary of content (4 pages)

PAGE 1
Cage read first REVIEW BEFORE ASSEMBLY • TOOLS: Allen wrench (included). Needle nose pliers (not included) will be useful. If power tools are used, Prevue is not responsible for damage caused by misuse. • Two-person assembly for best results. 1 To assemble the BASE, you will need these pieces: [ FIG. 1-1 ] ×4 ×4 Attach the storage shelf to the leg frames to create the base. Back ends of leg frames have a backstop tab at the track ends (fig.1-1).
PAGE 2
3 To assemble the BACK, you will need these pieces: Back panels are identical and interchangeable. Install bottom panel by: • inserting top extended wire into the side frame (fig. 3-1); • aligning bottom frame with hole in side frame (fig. 3-2), and; • securing panels together with a screw in each lower corner (fig 3-3). Repeat for top back panel (fig 3-4). [ FIG. 3-1 ] ×2 [ FIG. 3-2 ] ×2 [ FIG.
PAGE 3
5 To install PERCHES and CUPS, you will need these pieces: ×4 Hang food/water cups under the doors in the side panels. Insert perches around the cage in appropriate places. ×3 6 × To assemble the FRONT, you will need these pieces: Loosen (but don’t remove) the two front corner screws of the roof to allow for installation of front panels. • Align extended wires on lower front panel with holes on side frames; • align bottom corners with screw holes on side frames.
PAGE 4
7 To complete the assembly, you will need these pieces: Slide the grille and the tray in place. Install the windbell lock (fig. 6-1). Your cage is now fully assembled and ready for use. CLEANING INSTRUCTIONS Prolong the life of your Prevue Pet Products cage with these recommendations: • When cleaning the cage, use a mild soap and soft cloth or Teflon-resistant scrubber (such as Prevue’s Cage Saver non-abrasive scrub pad [#109]).