Installation & Assembly

2
CAT WINDOW PERCH
ASSEMBLY INSTRUCTIONS
ADDITIONAL TOOLS REQUIRED FOR ASSEMBLY OPTION B ONLY
PARTS LIST
A B C
PHILIPS SCREW DRIVER:NOT INCLUDED ELECTRIC DRILL:NOT INCLUDED 1/4”DRILL BIT:NOT INCLUDED
ANCHOR(2)
METAL BRACKET(2)
POLYURETHANE FOAM PAD
WITH TRICOT KNIT COVER(1)
1
MDF BOARD(1)
SCREW(2) FLOWERETTE KNOB(4)
D E C
PERCH ASSEMBLY
(OPTION A:MAXIMUM WEIGHT LIMLT 20LBS)
1
3
SCREW METAL BRACKETS ON THE BACKSIDE OF THE
MDF BOARD WITH FLOWERETTE KNOBS. DO NOT TIGHTEN
THEM NOW.
REMOVE THE RELEASE PAPER FROM THE HOOK FASTENER.
PUT THE ADHESIVE PART OF THE HOOK FASTENER ON THE
WINDOWSILL IN POSITION DESIRED.
PLACE THE MDF BOARD ON THE WINDOWSILL WITH HOOK
AND LOOP FASTENER.ADJUST THE METAL BRACKET TO
THE WALL UNTIL MDF BOARD IS LEVEL .THEN FINISH
TIGHTENING BRACKETS IN THE CORRECTED POSITION.
PLACE POLYURETHANE FOAM PAD WITH TRICOT KNIT COVER ON THE MDF BOARD WITH HOOK AND LOOP FASTENER.
CHECK ALL PIECES FOR TIGHTNESS AND RE-TIGHTEN AFTER A FEW DAYS OF USE.
REMOVE THE HOOK FASTENER FROM THE BACKSIDE OF
THE MDF BOARD.
2
HOOK AND LOOP FASTENER
Hook Fastener
Release Paper
Adhesive part
4
Loop Fastener
Hook Fastener
Windowsill
Windowsill
Windowsill
Windowsill
Windowsill
Windowsill
Windowsill
5
3
PERCH ASSEMBLY
(OPTION B：MAXIMUM WEIGHT LIMIT 35LBS)
1
3
SCREW METAL BRACKETS ON THE BACKSIDE OF THE MDF
BOARD WITH FLOWERETTE KNOBS. DO NOT TIGHTEN
THEM NOW.
USE ELECTRIC DRILL WITH 1/4”DRILL MARKED 2 HOLES.
SCREW MDF BOARD INTO ANCHORS WITH SCREWS. ADJUST
THE METAL BRACKETS TO THE WALL UNTIL MDF BOARD IS
LEVEL THEN FINISH TIGHTENING BRACKETS IN THE
CORRECTED POSITION.
PLACE POLYURETHANE FOAM PAD WITH TRICOT KNIT
COVER ON THE MDF BOARD WITH VELCRO.
CHECK ALL PIECES FOR TIGHTNESS AND RE-TIGHTEN
AFTER A FEW DAYS OF USE.
PIN ANCHORS TO INSERT INTO HOLES.
PLACE THE MDF BOARD ON THE WINDOWSILL IN POSITION
DESIRED.MARK LOCATION OF SCREW HOLES
2
4
5 6
Please take a moment to read through the entire instruction booklet before assembly to
familiarize yourself with this product. Once you feel ready to start, follow the instructions
step by step and this should make this process as easy as we could make it for you.
Assembly Instructions
LOOK OUT WINDOW CAT BED