Installation & Assembly

3
To assemble the BACK,
you will need these pieces:
4
To assemble the ROOF,
you will need these pieces:
Back panels are identical and inter-
changeable. Install bottom panel by:
• inserting top extended wire into
the side frame (fig. 3-1);
• aligning bottom frame with hole
in side frame (fig. 3-2), and;
• securing panels together with a
screw in each lower corner (fig 3-3).
Repeat for top back panel (fig 3-4).
×2
×
×2
×
[ FIG. 3-1]
[ FIG. 3-2]
[ FIG. 3-3] [FIG. 3-4]
×4
×
• Align the roof panel with corners;
• Align extended wires from back
panel with holes on underside of
roof frame;
• Align extended wires of roof with
holes along side frames.
Secure roof with screws in each corner.
Note: The addition of the roof
stabilizes the cage during assembly.
The front two screws may be left
loose until the end of Step 5.