Installation & Assembly

1. REMOVE ENDCAPS
From the top unit, remove
the footer endcaps.
From the bottom unit,
remove the top endcaps.
2. REMOVE HEX SCREWS
From the bottom unit, remove
the four top corner hex screws.
3. INSERT PLASTIC
CONNECTOR POSTS
Into the frame corners of
the bottom unit, insert
the plastic connectors,
following the INSTALLATION
TIP at the top of the page.
4. REPLACE HEX SCREWS
On the bottom unit, replace the
hex screws in each top corner,
making sure to keep the roof
brackets in place.
5. STACK THE UNITS
After all corner connectors
and corner brackets are
installed securely, slide the
frame corners of the top unit
over the connector posts
on the bottom unit.
Three cage units can be stacked
safely. Do not exceed three
stacked cages.
INSTALLATION TIP :
Use the allen wrench to keep the plastic
connector from going too deeply into the frame,
and to align the holes in the post and frame.
TOOLS NEEDED :
An allen wrench and maybe
a screwdriver or pliers to
help in removing endcaps.
Breeding Cages
H
OW TO STACK
ASSEMBLED UNITS
1
You will need these pieces: