Installation & Assembly

ManualsBrandsTucker Murphy Pet ManualsAll Bird CagesWesley Small Dometop Bird Cage

× 8 sets

(short hex screws with nuts)

To assemble the DOMETOP

ROOF, you will need these

pieces:

Finish the assembly with the

SEED GUARDS

. You will need

these pieces:

To install the COMPONENTS,

you will need these pieces:

× 4 (long)

NOTE: Front and back dometop arch panels are interchangeable.

Lay a dometop panel on the floor. Set the roof panel

into place, inserting the extended wire into the hole, and

centering the roof edge within the channels.

Set the remaining dometop panel into place following

the same method. On the end facing you, loosely attach the

panel to the roof with two long hex screws.

With two hands holding the

dometop unit together,

set the unit into place onto

the posts on the cage frame.

Remove the two hex screws. Nestle the dometop

into place, inserting the extended wires on the

roof into the holes on the side frames. Secure

the roof in all four corners with long hex screws.

For both cups:

Open the cup door. Insert the cup holder into

the sleeves. Insert the cup into the holder.

For the perch:

Perch fits in the cage from side to side.

Install the perch on a horizontal wire, at the

same height on both ends.

For the grille and tray:

Slide the tray into the bottom channel.

Slide the grille into the top channel. Secure the

grille with the grille clip: catch the open-hook

ends onto the short horizontal wire; swing the

clip up and hook it over the grille handle.

Follow the illustration closely. Pre-assemble the

seed guard pairs by turning them upside down and

attaching them with short hex screw/nut pairs.

When both seed guard sets are pre-assembled,

the pair with the notches A fits along the front

and right side.

Have your allen wrench and screw/nut pairs at

the unfinished corners. Slip the remaining seed

guard pair into place and attach the open corners

with the remaining screw/nut pairs.