Installation & Assembly

Bird Cage

To begin the assembly of your

DOMETOP HOME

, you will need

these pieces:

To assemble the SIDES,

you will need these pieces:

read first

REVIEW BEFORE

ASSEMBLY

• An allen wrench is included.

No other tools are required.

• Hardware and assembly steps

• For best results, follow steps

in order.

Lay the front panel on its side. Slip the tab on the

short panel into the sleeve on the front panel frame.

Secure the short panel with a long hex screw.

In the same manner, add the

back panel and the opposite-side

short panel.

With the cage still on its side, add the

rolling casters into the frame legs.

Stand the cage upright.

Slide the side panels into place:

• The heavy vertical wires face the

cage exterior

• The handles on the cup door panel

face the cage exterior

• When sliding a panel into place,

keep the panel centered within all

channels on the front and back panel

frame rails

• The extended vertical wire at the

bottom will insert into the hole

in the side panel frame

× 4 (long)

× 4

PAGE 1
Bird Cage 1 read first REVIEW BEFORE ASSEMBLY • An allen wrench is included. No other tools are required. • Hardware and assembly steps • For best results, follow steps in order. Lay the front panel on its side. Slip the tab on the short panel into the sleeve on the front panel frame. Secure the short panel with a long hex screw. To begin the assembly of your DOMETOP HOME, you will need these pieces: In the same manner, add the back panel and the opposite-side short panel.
PAGE 2
3 NOTE: Front and back dometop arch panels are interchangeable. To assemble the DOMETOP ROOF, you will need these pieces: Lay a dometop panel on the floor. Set the roof panel into place, inserting the extended wire into the hole, and centering the roof edge within the channels. Set the remaining dometop panel into place following the same method. On the end facing you, loosely attach the panel to the roof with two long hex screws.