Installation & Assembly

1
a
Assemble the base: Lay the back lower (B1)
and the front lower (F1) frames on their sides.
Install the bottom storage shelf (C1) panel
with four hex screws. Tighten securely to create
a stable base.
1
b
While the cage is on its side, insert a rolling
caster wheel in each leg post.
2
a
Assemble the lower half: Stand the cage upright.
→
The side rails have small holes along the top surface of
the frame which align with extended vertical wires on the
side lower (L2) & (R2) panels. The side rails also have track
channels along the inside surface for the grille & tray.
The holes should be facing up and the tracks should be
facing the cage interior.
Attach the left lower (L1) and right lower (R1) side
rails with hex screws, through the leg frames, into
each end.
2
b
The side lower (L2) & (R2) mesh panels have one spring-
loaded door in each panel. They also both have vertical
wires extending above and below the panel.
Slide the right side lower (R2) panel down through
the channels along the inside rails of the front and back
panel frame (see detail [a]). Align the extended wires
at the bottom with the holes on the top surface of the
lower rail (R1) (see detail [b]).
Install the left side lower (L2) panel in the same
manner. When installed correctly, doors will open out.
steps
3
a
Assemble the upper half:
→
The front upper (F2) and back upper (B2) panels have
posts on the lower frame legs which align with holes
in the frame of the front lower and back lower panels
(see detail [c]). The upper panels also have extended
vertical wires in the mesh portion which correspond
with holes along the top surface of the lower frame.
Stack the front upper (F2) panel onto the front lower
(F1) frame. Align the upper frame corner posts into
the lower frame corner holes. Align the upper frame
extended vertical wires with the lower frame holes.
Stack the back upper (B2) panel onto the back lower
(B1) panel in the same manner.
3
b
The middle (L3) & (R3) side rails have small holes along
the top and bottom surfaces of the frame which align
with extended vertical wires on the side lower (L2) & (R2)
and side upper (L4) & (R4) panels.
Attach the left middle (L3) side rail by aligning the
holes along the bottom surface with the extended wires
along the top edge of (L2), and securing the rail with
hex screws, through the leg frames, into each end.
Install the right middle (R3) side rail in the same
manner.
3
c
The side upper (L4) & (R4) mesh panels have two spring-
loaded doors in each panel. They also both have vertical
wires extending above and below the panel.
Slide the right side upper (R4) panel down through
the channels along the inside rails of the front and back
panel frame (in the same manner as Step 2b). Align the
extended wires at the bottom with the holes on the
top surface of the middle side rail (R3).
Install the left side upper (L4) panel in the same
manner. When installed correctly, doors will open out.
C1
F1
L2
L1
R2
R1
F1
B1
F2
B2
B1
(a)
(b)
(c)
L4
R4
L3
R3