Installation & Assembly

ManualsBrandsTucker Murphy Pet ManualsAll Bird CagesElsie Extra Large Flight Bird Cage

KEY:

L = Left panels

B = Back panels

R = Right panels

F = Front panels

C = Center (Shelf & Top)

cage assembly instructions

Flight Cage

cage: 37"L × 23"W × 60"H

interior: 36⅛"L × 22⅛"W × 47"H

wire gauge: 8 & 12

wire spacing: ½"

getting started!

READ THESE NOTES FIRST:

• Enlist A Friend:

While this large cage may be assembled by

one person, several steps would be made easier with two people.

• Review All Parts: If wires are bent during shipping, they may

be straightened with needle nose pliers.

• Tools:

You will need needle nose pliers to remove slugs and

straighten wires. You may use your own hand tool with an allen

wrench bit. We DO NOT recommend power drills. Parts can be

over-tightened and damaged/stripped.We are not responsible

for this type of damage.

parts

With the cage completely assembled, rotate the

windbell lock to one side and slide the grille (G)

and tray (T) into position; grille in the upper track,

tray in the lower track.

4 Assemble the roof:

Side rails on the roof (C2) panel have small holes along the

bottom surface which align with extended vertical wires on

the side upper (L4) & (R4) panels. There are also extended

wires along the front and back edge of (C2) which align

with holes along the inside surface of the front and back

(F2) & (B2) frames.

Align the top (C2) panel by aligning holes and extended

wires. Secure the roof with hex screws in each corner.

6 When the cage is completely assembled, insert the

food/water cups into the side doors (see detail [d])

and install the perches (see detail [e]).

✩

Your cage is now fully assembled!

CLEANING INSTRUCTIONS

Prolong the life of your cage

with these

recommendations:

When cleaning the cage, use a mild soap and soft

cloth or Teflon-resistant scrubber (such as Prevue’s

Cage Saver non-abrasive scrub pad (#109)).

After washing, dry the cage thoroughly with a dry

soft cotton cloth to prevent rust.

Wash the tray with soap and warm water. DO NOT

leave tray to dry in the sun, as the tray can warp.

Hand dry the tray and grille with a soft cotton cloth

before placing back into cage.

LEFT SIDE

FRONT

BACK

RIGHT SIDE

GRILLETRAY

{16} hex head screws

{1} allen wrench

{ 3 } wood dowel perches

{ 4 } plastic cups

{ 4 } rolling casters

(d)

(e)

Summary of content (2 pages)

PAGE 1
5 6 Assemble the roof: Side rails on the roof (C2) panel have small holes along the bottom surface which align with extended vertical wires on the side upper (L4) & (R4) panels. There are also extended wires along the front and back edge of (C2) which align with holes along the inside surface of the front and back (F2) & (B2) frames. Align the top (C2) panel by aligning holes and extended wires. Secure the roof with hex screws in each corner.
PAGE 2
steps 1a 3a C1 Assemble the base: Lay the back lower (B1) and the front lower (F1) frames on their sides. Install the bottom storage shelf (C1) panel with four hex screws. Tighten securely to create a stable base. F1 1b While the cage is on its side, insert a rolling caster wheel in each leg post. 2 2b The side lower (L2) & (R2) mesh panels have one springloaded door in each panel. They also both have vertical wires extending above and below the panel.