Installation & Assembly

]Pc
]Cc
3
PIECES
4
PIECES
Assembly completed. {
Loosen the knob screws on the perch bar rail and along the
cage front. Insert the ladder and re-tighten the knob screws.
Remove the hex screws from the ends of the
perch bar supports. Install the perch bar supports
on the back panel of the cage.
Cups/cup holders:
Open the cup door.
Insert the screw post
on the cup holder
through the door
mesh, add the bracket
on the outside, and
tighten to the door
with a wing nut.
Place a deep cup into
the holder.
Grille and tray:
Open the grille lock.
Slide the grille (with
handle) into the top
channel and the deep
tray into the bottom
channel.
Perch:
Hold the perch in place in the
cage interior. On the exterior, align
a Phillips-head screw through the
bracket, through the cage wire, into
the perch bracket. Tighten. Requires
four screws to secure the perch bar.
When fully assembled, check and tighten
ALL screws and wing nuts over the entire
cage to ensure a safe and stable home.
⁕
Attach the perch bar unit to the support rails
with allen-head screws.
Loosen the perch brace screws and tilt the perch back.
Install the cup holder brackets using Phillips-head screws.
Rotate the perch back in place and retighten the brace
screws. Insert the shallow cups.
Open the grille lock.
Slide the thin grille
into the top channel
and the shallow tray
into the bottom
channel.
Shortest side →
Longest side
↓