Installation & Assembly

]R
]B
]Ls
]Rs
]F
KEY:
B = Back panel
F = Front panel
LS = Left side
panel
RS = Right side
panel
R = Roof grille
C = Casters
CC = Cage
Components
PC = Playtop
Components
TOOLS NEEDED : Phillips head screwdriver • For best results, follow Assembly Steps in order presented.
2
PIECES
Stainless Steel
]C
1
PIECES
Back the Phillips-
head screws out,
align the side panel
unit with the front panel
unit, and re-tighten the
screws to attach.
Repeat this method for all
panel units to assemble
the cage body.
Set the cage roof grille
in position and attach with
Phillips-head screws.
Screws are installed in place. When attaching
panels or components, back the screw out, match
up the components, and reinsert to attach.
⁕
In most cases, we recommend
two people assemble this cage.
⁕
Note: On the back panel, the small loop
should face the interior. This loop helps
hold the bottom grille in place.
While the lockable rolling
casters can be added at any
point in the assembly, we
recommend installing them
at this time.
Screw the threaded caster post
into the frame leg at each corner.
If preferred, tighten each caster by
the base nut with a slim wrench.