Installation & Assembly

INSTALLATION INSTRUCTIONS:
PLAYHOUSE
PAGE
7/8
5
LATCH POST ASSEMBLY (CONTINUED) (a s t ep s to ol or l a dder is reco mmended)
5H. Slide the vertical tube
A left until tube A is
between the padlock
holes and the metal
spacer as shown in
diagram 5I. Position
the tube so that it is
not touching the metal
spacer as shown.
Once in position
tighten the nuts on
the upper and lower T
clamps B from steps
5E-5G.
At this point you should
have the entire frame,
gate, hinge, and latch
fully assembled as
shown in diagram 5J.
5H 5I
A
A
B
A
A
5J