Installation & Assembly

Slide(1) post over each
Ground Anchor Stake.
(5) 35" Posts
(4) 46"" Posts
(8) Rail Connectors
1
(5) Ground Anchor Stakes
Insert (1) Ground Anchor Stake every
4' on center using a rubber mallet. Leave
12"-18" exposed. Be sure stakes face the
proper direction. Stakes can be set in
concrete if desired.
You will need a rubber mallet, electric drill,
tape measure, gloves and wire snips for this
project
2
3
Connect (2) Rail Connectors to
each side of a 46" Post. Be sure
that the opening faces the same
direction on each end. Repeat four
times.