Installation & Assembly

1
(8) Ground Anchor Stakes
Insert (1) Ground Anchor Stake every
4' on center using a rubber mallet. Leave
12"-18" exposed. Be sure stakes face the
proper direction. Stakes can be set in
concrete if desired. (Optional - Only for
permanent installation)
You will need a rubber mallet, electric drill,
tape measure, gloves and wire snips for this
project
2
Slide(1) post over each
Ground Anchor Stake.
(12) 35" Posts
3
Connect (2) 46" Rails to a Corner
Rail Connector. Add (1) Rail
Connector to each open end as
shown below. Repeat four times.
(8) 46" Rails
(4) Corner Rail Connectors
(8) Rail Connectors