PE-8X16 8' x 16' Pet & Garden Enclosure
1 Insert (1) Ground Anchor Stake every 4' on center using a rubber mallet. Leave 12"-18" exposed. Be sure stakes face the proper direction. Stakes can be set in concrete if desired. (Optional - Only for permanent installation) (8) Ground Anchor Stakes You will need a rubber mallet, electric drill, tape measure, gloves and wire snips for this project 2 3 Slide (1) post over each Ground Anchor Stake. (12) 35" Posts Connect (2) 46" Rails to a Corner Rail Connector.
4 Slide parts from Step 3 over Corner Posts to the bottom of your enclosure. Secure into place with provided screws. 5 6 Attach parts from Step 5 to the remaining openings of your enclosure. Secure into place with provided screws. 7 Connect (2) Rail Connectors to each side of a 46" Post. Be sure that the opening faces the same direction on each end. Repeat four times. (4) 46"" Posts (8) Rail Connectors Connect (2) Rail Connectors to each side of a 46" Post.
8 Connect (4) 3-Way Elbows to the corners of your enclosure. 10 (4) 3-Way Elbows Attach (1) Elbow to the remaining post top. Face it as shown below. (1) Elbow 9 11 Connect (7) Tee's to the center posts as shown below. Exclude the center post at the front of your enclosure. Attach (11) 46" Rails to the top of your enclosure using a rubber mallet. Leave only the space where your gate will be installed open.
12 Connect (1) 19 7/8" Rail to (1) 33 1/4" Post with the Elbow. Add (1) Rail Connector to open end of post facing the direction indicated below. 14 Connect (2) 19 1/2" Gate Rails to (2) 28 1/2" Gate Posts using the included Hinge Elbows. IMPORTANT: Holes in Elbows must be facing up and down to attach to hinges properly. (1) Elbow (1) 33 1/2" Post (1) 19 7/8" Rail (1) Rail Connector (4) Hinge Elbows (2) 19 1/2" Gate Rails (2) 28 1/5" Gate Posts 13 15 Snap parts from Step 12 to gate opening.
13 Unroll wire and allow it to straighten. Attach to enclosure using providing screws. Pull tightly before each screw to ensure best result. Trim wire with wire snips as you go, installing 4'-8' at a time. Enough is provided to cut a piece to cover gate panel as well. 14 Add Support Brackets as desired along the bottom of your enclosure for additional support. Secure with provided screws.
Free custom project assistance.