Assembly Instructions

1
a
Assemble the cage base:
Note: The lower left (L1) and right (R1) side panels are inter-
changeable. Orient the side panels so the tray/grille channels
on the lower portion face into the cage. Center the right side
lower (R1) panel into the channel on the interior frame rail of
the front lower (F1) panel (see fig.1-1) and have your assistant
hold the panels in place. Install long hex screws through the
front panel in the two lower positions indicated.
1
b
Attach the back lower (B1) panel to the (R1) side panel with
two long hex screws in the lower holes. Slide the left side
lower (L1) panel into place in the channels on the front and
back frame rails. Complete the assembly with two long hex
screws in front and two in back, in the lower holes as indicated.
Make sure all screws are tightened for a snug hold.
3
b
Repeat the installation steps for the front upper (F2) panel,
inserting posts on the front upper panel into holes at the
outside and door opening corners of the front lower panel,
and attaching with one long hex screw in each outside corner.
3
c
Side left upper (L2) and side right upper (R2) panels are
interchangeable and can be swapped depending on your
preference. Orient the panels with the cup doors on the lower
portion and make sure the doors swing open to the outside
of the cage.
Slide the panels into place, centering them into the channels
along the vertical frame rails of the front and back panels
(see fig.3-3). Align the extended mesh wires at the bottom
edge of these panels with the small guide holes on the top
surface of the frame rail on the side lower panels (see fig.3-4).
B1L1
B2
Made in China
2Carefully lay the cage on its side as illustrated and insert a
rolling caster in each leg post.
If casters are too tight to insert fully by hand, you may try
carefully placing a flathead screwdriver at the base of the
caster and gently taping the caster into place with a rubber
mallet (see fig.2-1).
After the casters have been installed, carefully upright the
cage and continue assembly.
3
a
Assemble the cage upper half:
Slide the leg posts on the back upper (B2) panel into
the corner holes in the frame of the back lower panel
(see fig.3-1). Align the extended mesh wires along the
bottom horizontal edge of the back upper panel with
the small guide holes on the top surface of the back
lower panel frame rail (see fig.3-2).
Once everything is aligned and fully nestled into place,
attach with one long hex screw in each corner (see fig.3-1).
4
a
Assemble the cage roof:
With help from your assistant, guide the center roof (C1) panel
into place, centering the front and back horizontal wires into
the channels along the front and back panel inside frame rails.
Loosely
assemble center roof panel with a long hex screw in
the four corners as indicated. Do not fully tighten the screws.
4
b
Catch the hooks along the upper rail of the center right roof
(C2) panel into the hooks along the horizontal frame rail of
the center roof panel (see fig.4-1). Align the sides of this roof
panel into channels along the front and back panel frame rails.
Align the guide holes along the lower frame rail with the
extended mesh wires along the top horizontal edge of the side
upper panel (see fig.4-2). Attach with one long hex screw in
each lower corner. Repeat for center left roof (C3) panel.
Finish by tightening center top roof panel screws.
steps
F1
R1
(
fig.1-1)
(fig.2-1)
(fig.3-2)
(fig.3-3)
(fig.3-4)
(fig.4-1)
(fig.4-2)
(fig.3-1)
L2
R2
F2
C1
C2
C3