Installation & Assembly

3
P
IECES
4
PIECES
Assemble the hideaway house by flipping the sides upright
and pushing the tabs into the slots until they click.
Align the pegs on the underside of the roof into the slots
on the side walls until they click in place.
Set the “L” hook ends of
the platform down over the
center-height horizontal wire.
Set the inverted “V” hook
ends of the ladder onto the
platform and let the other
end rest on the floor grille.
Remove the wing nut from the back of the house.
Place the house in position on the platform,
poking the screw post through the wires.
From the back of the cage, replace the wing nut.
Tighten until snug.
Place the wheel in the cage near the floor level.
Align the bar on the back to fit between, and through,
the cage wires. From the exterior of the cage, rotate
the bar 90° to secure the wheel in place.
Assembly completed. {
]A
]R
Center the roof on the cage. Starting on one side, catch the outer roof wire
under the loops on the side panel. Softly bend the roof mesh to catch the
roof line onto the front and back panel loops.
Finish by catching the roof onto the opposite side panel loops.
For more wonderful cages, toys, and accessories for dogs, cats, birds, chickens, rabbits, ferrets and small animals.