Installation & Assembly

TWO-

STORY

PIECES

Attach the back panel to the three-panel unit:

Start at the lower corner. Hook the right side onto

the back panel, then weave the alternating hooked wires

of the two panels together, up the seam, to the top.

Repeat the method with the opposite seam

(left-side panel to back panel).

Set the assembled

mesh into the base,

catching the bottom

wire of the side

panels under the

tabs along the rim.

Set the grille into the base.

Push the tray into the base (if loose).

NO TOOLS REQUIRED • For best results, follow Assembly Steps in the order they are presented.

KEY:

M = Mesh

B = Base

= Accessories

G = Grille

T = Tray

= Roof

PIECES

Made in China

Hamster Gerbil Home

PAGE 1
Hamster Gerbil Home TWOSTORY NO TOOLS REQUIRED • For best results, follow Assembly Steps in the order they are presented. KEY: M = Mesh B = Base A = Accessories 1 G = Grille T = Tray R = Roof PIECES ] M Attach the back panel to the three-panel unit: Start at the lower corner. Hook the right side onto the back panel, then weave the alternating hooked wires of the two panels together, up the seam, to the top. 2 Repeat the method with the opposite seam (left-side panel to back panel).
PAGE 2
3 PIECES Set the “L” hook ends of the platform down over the center-height horizontal wire. 4 ] A Assemble the hideaway house by flipping the sides upright and pushing the tabs into the slots until they click. Remove the wing nut from the back of the house. Place the house in position on the platform, poking the screw post through the wires. From the back of the cage, replace the wing nut. Tighten until snug.