Installation & Assembly

]B
]C
]
Lm
1
PIECES
2
PIECES
]T
2
]T
2
]T
1
]T
1
]W
2
]W
2
Insert the bar on the back of the wheel
through, the cage wires. Rotate the bar 90° to
secure the wheel to the mesh.
Firmly but gently wiggle the ring on the
three-curve tunnel trail into the opening of
the holder on the side panel.
Install a platform with the ramp notch in the
front, catching all tabs on a horizontal wire at
an even height. Add the ramp to the platform.
Insert the second platform and ramp.
Install the second wheel.
Insert a single-curve tunnel trail into the holder.
Open the lower mesh (sides are equal in height
to the front & back panels) to a rectangle.
Set the mesh into the base, inserting the panels
between the rim and the raised tabs.
Clip the mesh to the
base on both sides of
the cage.
]Pr
1
]Pr
1
]Pr
2
]Pr
2
]W
1
]W
1
For more wonderful cages, toys, and accessories for dogs, cats, birds, chickens, rabbits, ferrets and small animals, visit our websites.