Owner Manual

Assembling & Using Your Product
Unpack all components carefully. Please check to ensure all parts have been
removed from the packaging. Some splashing may occur.
Components:
 Fountain
 LED Light
 Pump
 Transformer
Assembling:
1. Place fountain on smooth and leveled surface.
2. Open hatch behind the fountain. Connect the LED light strand inside the
fountain to the adaptor. See figure 1, 2, 3and 4above.
3. Adjust the flow control to the lowest setting to avoid splashing until the
fountain is completely assembled. Connect the vinyl tubing to the pump. And
place the pump inside the fountain in open middle area.
4. Gently pour water in the fountain, being careful not to overflow and cause
splashing. Make sure the water completely submerges the pump. See figure
5 above.
5. Plug the transformer and pump cord into your local power supply. Make sure
that there is no water around the transformer and always keep the power
source in a dry place.Make sure the water runs clear during operation. See
figure 6 above.
o NOTE: We recommend that you use distilled water to prevent scale
build-up. The first time you operate the pump it can take up to 5
minutes for the air to be completely expelled and water begins to flow
properly.
Trouble Shooting & Caution
If you have any questions and/or problems, please contact the retail store you
purchased this fountain.
 If your pump fails to run
 Check the circuit breaker or try a different outlet to make sure the pump is
receiving electrical power.
 Check the pump discharge and tubing for any kinks and/or obstructions
 Any buildup obstructing the water flow can be flushed with a garden hose
 Check the rotor by removing the front cover & plate to access the impellor area.
Turn the rotor and make sure that the rotor is not jammed or broken
 If your pump “spews”
 Check the water level to make sure the pump is completely submerged and
there if enough water in the basin to operate your fountain. Not having enough
water will cause your pump to spew
 If your pump is making abnormal loud noises
 Disconnect the pump from the electrical power supply and remove the front
cover & plate
 Carefully grip the impeller and gently pull the impeller/rotor assembly out of the
pump housing
 Rinse the impeller/rotor assembly and clean the cavity with clean water. If
breakage or damage is found, contact your local retailer for part
 Caution
o Always unplug the pump from the electrical outlet before
cleaning & handling
o Uses with clean water only, do not place the fountain and/or
parts in any other liquid.
o Periodically change water & clean the pump to keep free
from micro-organisms
o Disconnect and store the unit in a dry place if not in use for
an extended period of time
o Do not operate with water above 90°F or 30°C
o Do not lift, carry or pull the pump by the power cord
o Do not exceed the maximum voltage & wattage on
transformer
o NEVER LET THE PUMP RUN DRY