Assembling Instruction

Wooden stud Drywall connection

Metal stud Final assembly

Advice:

Please note the secure assembly and mounting requires one

adult person. When using drywall anchors, we strongly recommend

combining the drywall connection with at least one screw to a stud

for a more solid connection.



Work Steps:

First Step (connection with stud)

Please use a stud ﬁnder (or other technique) and a pencil. After

locating the stud mark the center of the stud, which will hold the

product.

Bring the products in ﬁnal position and mark the screw-point on

the center of the studs. Use a spirit level or have someone eyeball

to make sure the holes are levelled.

First Step (connection with drywall anchors)

Locate the ﬁnal position of mark the board and mark the screw-points.

Use a spirit level or have someone eyeball to make sure the holes

are levelled.

Second Step (Pilot hole)

Use your drill and a 1/16“ or 5/65” bit to make pilot holes for

maximum 2 inch to all markings. Please make sure to use the right

bit for wooden and metal studs.

Third Step (connection with stud)

Mount the board with enclosed screw and washer to the stud

and make sure the screws are fastened securely. We provide

wood-screws and metal-screws for each type of studs.

Third Step (connection with drywall anchor)

Use your drill and with a Phillips bit to drill the anchors into the

dry wall. The anchors are self-drilling. Mount the board with

enclosed wood-screws and washers to the anchors and make sure

the screws are fastened securely.

a. Metal Srew

b. Wooden Srew

c. Drywall Anchor

d. Washer