Assembly Instructions

Table Of Contents

Important Notes:

Lay out all components prior ro start of

assembly.

Flat level surface recommended for

assembly.

If any components are missing or

damaged do not return to retailer.

Please visit our website to see our

complete line of products.

PAGE 1
Important Notes: Lay out all components prior ro start of assembly. Flat level surface recommended for assembly. If any components are missing or damaged do not return to retailer. Please visit our website to see our complete line of products.
PAGE 2
Step 1 Assemble as shown using two (2) clamps (L) per panel. Step 3 Add Handle Bar (H) to back end using two (2) bolts (M). Bolts will enter handle from inside the cage. Step 2 Add wheels (K) to front end of pen, fastening with washer and bolt. Important to make sure wheel nut is tight! Step 4 Add both Support Bars (I) and Perch (J) using two bolts (M) per bar. Don’t tighten all bolts until the end.