Instruction Manual

Lydkraft ApS
Mose Allé 20, DK2610 Rødovre
Denmark
6
HIGH BAND:
1) Turn all the THRESHOLD-controls fully counter-clockwise.
2) Turn the HIGH BAND GAIN-control fully clockwise.
3) Turn the LOW BAND and MID BAND GAIN-control fully counter clockwise.
4) Set the X-OVER HIGH at 1,2k.
5) Apply a signal of 10 kHz, (approx. -20 dBU) to the input and adjust the input level
for an output reading of 0,0dBU.
6) Move the jumper on the high band side chain PCB (top most PCB) to “ADJUST”
and observe that the output level has dropped to -10,0 dBU.
7) If this is not the case, adjust the gain reduction with P61, to obtain a drop of -10,0 dB.
10) Adjust the high band display with P62 so the green -10 LED turns on and the
green -7 LED just turns off.
(041121)