User's Manual

B. MIBS
64 "COM/MON error detected by the TTE -SwE on the respective port .
65 Each port is represented by a bit, port 0 at bit 0, port 1 at
66 bit 1 and so on.
67 0: No error occurred .
68 1: A COM/MON mismatch was detected at the respecitve port."
69 ::= { tteSwitchingEngineVnV 6 }
70
71 tteSweOutOfMemCond OBJECT - TYPE
72 SYNTAX INTEGER (0..67108863)
73 ACCESS read -only
74 STATUS mandatory
75 DESCRIPTION
76 "Out -of -memory conditions detected by the TTE -SwE.
77 0: No error occurred .
78 1: An out -of-memory condition occurred in one of the
79 TTE -SwE 's memory partition ."
80 ::= { tteSwitchingEngineVnV 7 }
81
82 tteSweAccessMode OBJECT -TYPE
83 SYNTAX INTEGER (0..2)
84 ACCESS read -write
85 STATUS mandatory
86 DESCRIPTION
87 "Access mode for the TTE - SwE IP. Possible values are:
88 0: TTE_SWE_CM_ACC_MODE_COM_MON
89 Request is sent to COM and MON module.
90 1: TTE_SWE_CM_ACC_MODE_COM
91 Request is sent to COM only .
92 2: TTE_SWE_CM_ACC_MODE_MON
93 Request is sent to MON only . NOTE: If not MON is given in
94 the system an status query might fail or provide invalid
95 data."
96 ::= { tteSwitchingEngineVnV 8 }
97
98 tteSweSyncState OBJECT -TYPE
99 SYNTAX INTEGER (0..8)
100 ACCESS read -only
101 STATUS mandatory
102 DESCRIPTION
103 "Current state of the synchronization engine.
104 Possible values are:
105 0: INIT
106 1: INTEGRATE
107 2: UNSYNC
108 3: WAIT 4 CYCLE START
109 4: CA ENABLED
110 5: WAIT FOR IN
111 6: TENTATIVE SYNC
112 7: SYNC
113 8: STABLE"
114 ::= { tteSwitchingEngineVnV 9 }
115
116 tteSweClockCorrSmallest OBJECT - TYPE
117 SYNTAX INTEGER
118 ACCESS read - only
119 STATUS mandatory
© TTTech Computertechnik AG 2019. All rights reserved.
Confidential and Proprietary Information
41
Document Number:
D-863-M-05-001