User's Manual

7. DIAGNOSIS
The parameter <filename> can be one of the following names:
CONFIGS_BAK Backup configuration image in the dataload area
CONFIGS_DEF Default configuration image in the dataload area
FIRMWARE_BAK Backup firmware image in the dataload area
FIRMWARE_DEF Default firmware image in the dataload area
NOTE
It is not recommended to upload larger files due to the slow transfer speed of the serial interface (2 kb/s).
When using the file upload command, you must specify the file size in bytes, as displayed in the file
properties (Right-click > Properties > Size).
>file upload thw_id_conf.smc 15
Please wait , preparing ...
Ready to receive ...
Wait until the message Ready to receive… appears and then upload the raw bytes (choose the binary
file transfer option) via your terminal application. See Figure 11 on this page for an example.
Figure 11: Binary file transfer option in Tera Term
It will take some time for the switch to process the file. If it does not take the switch any time to process
the file, the uploaded file was already present in the switch and nothing was changed.
The message Successfully wrote file indicates that the upload has been successful. If a CONFIGS_BAK
file was uploaded, this message will be followed by the message Successfully updated active page.
7.5.3 Port commands
The RS-232 command for mirror ports is:
Command Arguments Description
mirror <port>
[mirror port]
[direction]
Get the mirror port for port <port>. Alternatively, set the mirror port of
port <port> to [mirror port]. Use the strings RX, TX, or RXTX to set
the [direction].
7.5.4 Event log
The sys eventlog command shows the complete event log with a timestamp (in seconds) and the event
ID.
© TTTech Computertechnik AG 2020. All rights reserved.
Confidential and Proprietary Information
33
Document Number:
D-A664Lab-G-05-001