User's Manual
Table Of Contents
- Front Cover
- Table of Contents
- List of Tables
- List of Figures
- Disclaimer
- Limited Rights Notice
- 1 Introduction
- 2 Overview
- 3 Functional description
- 4 Getting started
- 5 State machine
- 6 Creating a switch configuration
- 7 Diagnosis
- 8 Troubleshooting
- Appendix A List of Built-In Self-Tests
- Appendix B Serial terminal output at start-up
- Glossary
- References
- Index
6. CREATING A SWITCH CONFIGURATION
Operation Command and Description
Find tt_615a3_console_w.exe -c cfg.loading_configuration -f
Check if all clients specified in the configuration file exist in the network.
Information tt_615a3_console_w.exe -c cfg.loading_configuration -i
Retrieve additional information on each client specified in the configuration file.
Upload tt_615a3_console_w.exe -c upload.loading_configuration -u
Upload the files specified in the upload.loading_configuration to the TTE-Switch A664 Lab
v2.0.
Table 9: TT-615A3-Loader operations
6.6 Configurable Target Hardware ID
The file thw_id_conf.smc contains the Target Hardware ID for A615 data loading. The Target Hardware
ID has a maximum length of 15 alphanumeric characters. To display the Target Hardware ID, open a CLI
window, type sys thwinfo and press Enter :
>sys thwinfo
Target Hardware Identifier: TTESMC2DEMOAPP
Target Type Name: TTESMC2DEMOAPP
Literal name: TTESMC2DEMOAPP
Manufacturer code: TTT
Target Position : SW0
>
To update the Target Hardware ID, the file can be modified via A615 data loading or RS-232 serial interface:
• A615 data loading: Upload the file thw_id_conf.smc via data loading.
• RS-232 interface: Open a CLI window, type file upload thw_id_conf.smc <size in bytes> and
press Enter . For details about this command, see Section 7.5.2 on page 32.
NOTE
After uploading the file thw_id_conf.smc, a reset is necessary to update the Target Hardware ID.
© TTTech Computertechnik AG 2020. All rights reserved.
Confidential and Proprietary Information
29
Document Number:
D-A664Lab-G-05-001