User's Manual

128-xxxx
15 of
15
Transmit Power Selection Mode
This feature permits selection of the transmitting power level to high
or low. Using low power the unit will have a lower transmit range but
battery life will be increased.
To access the transmitter power selection function:
- From GMRS standby mode, press the Function Button until the Po icon
appears with a flashing HI or Lo indication on the display.
- Press the Up or Down button to toggle between the High and Low se-
lections.
- Press the PTT or Power On/Off button to confirm selection.
The display will indicate the current setting in standby mode.
Roger Beep Tone
The Roger Beep is a tone which is automatically transmitted whenever the
PTT button is released. This tone alerts the receiving party that the trans-
mission has been terminated intentionally.
To enable and disable the Roger Beep tone:
- From GMRS/FRS standby mode, press the Function Button until rb
appears on the display with the flashing Roger Beep icon (
) and
On or oF.
- Press the Up or Down Button to select the tone on or off as desired.
- When enabled, the tone icon (
) appears steady on the display.
- Press the PTT or Power On/Off button to confirm selection.
Battery Alert
When the battery icon ( ) blinks on the LCD panel, recharge unit or
install fresh batteries.