User's Manual

11/21
9) Call Ringer Selection Mode
This feature Provides 3 user selectable call ringer signal.
To set your favorite call ringer signal.
* Press the MODE button until the [
C 01
or up to
03
] appears on the LCD.
* Press the up[ù]or down[ü] button to select the call melody type.
* Press the PTT button to confirm.
* To activate the call, click the “PTT” button twice quickly.
10) Transmitting
* Press and hold the PTT button (The LED light red during transmission.)
* Speak slowly and clearly
* To Stop the transmission, release the PTT button.
* if there are no more receiving signal for 5 seconds, the unit will go into
power save mode.
11) Receiving
The Coding feature reduce the possibility of interference and provide enhanced
Communication. You can only listen to a call that has correct matching code.
** Upon receiving a signal, the LED lights green. When radio is on CTCSS mode
and then a signal that has different CTCSS code on the same channel is received,
the LED blinks in green.
Important :
Before transmitting or receiving to the other parties
* Correct channel is selected (1 to 14) and
* Correct code is set ( 00 to 38 )
12) Channel Scanning
This feature allows you to monitor all activated channels while scanning.
To activate the Scan
* Press the SCAN button
* Radio will begin scanning.
* When in scan mode, the display will show each scanning channel.
* After an activated channel is scanned and received signal and then if there is
no more signal, the scan will resume automatically
** Once a channel has been scanned, pushing the monitor button makes the
radio resume the scanning with the scanned channel skipped.
13) Call
* Click the PTT button twice quickly.