User's Manual

FRS-1000
Instruction Manual
00-12-30
- 6
4) Monitoring the channel
It is used for listening the weak signal or to here all activities on the channel by manually overriding
channel code setting.
To activate the Monitor feature
! Press and hold the
MON
button for over two seconds.
! When you here the sound, release the
MON
button.
To disable the Monitor feature
! Press and hold the
MON
button for over two seconds.
5) Auto Channel and tone code(CTCSS) Scanning
This feature allows you to monitor all channels and tone codes(CTCSS) automatically for valid signal.
While scan, you can transmit and receive.
To activate the Channel Scan
! Press the
Scan
button
! Radio will begin scanning for all channels.
To disable the Channel Scan
!
Press the
SCAN
button again
!
Radio will return to normal operation.
To activate the tone code(CTCSS) Scan
! Press the
Mode
button 2 times.
! Press the
Scan
button
! Radio will begin scanning for all tone codes(CTCSS).
To disable the tone code(CTCSS) Scan
!
Press the
SCAN
button again
!
Radio will return to normal operation.
6) Transmitting
! Press and hold the PTT button (The red LED will be illuminated)
! Speak slowly and clearly
! To stop the transmission, release the PTT button
! The unit will go to the stand-by mode
7) Dual Watch Scan Channel and tone code(CTCSS)
This feature allows you to monitor two special channel when the radio is in scan mode. The assigned
channel will be scanned between channel and channel.
Example : Dual Watch channel is 2 and 5 channel. When you are in
SCAN
mode ,it will be scan as
follows;
CH2 - 5 - 2 - 5 - 2 ..…
To set the Dual Watch Scan Channel
! Press the
Mode
button until the
DW
Icon blinks on the LCD.
! Press the up[ ] button or down [ ] button to select the Dual Watch channel.
! Press the Power Button to scan your selection.
To set the Dual Watch Scan tone codes(CTCSS)
! Press the
Mode
button until the
DW
and ctcss channel Icon blinks on the LCD.
! Press the up[ ] button or down [ ] button to select the Dual Watch tone code(CTCSS).