User's Manual

Selecting a channel

A. Select Channel by using CH+/- or the number buttons.

• Selelct the memorized channels, use CH+/- or the number buttons.

• Selelct the non-memorized channels, use the number buttons.

B. To use the number buttons:

e.g. Analog TV channel -When selecting channel 12, press 1, press 2, then press OK.

e.g. DTV channel-When selecting digital channel 12.3, be sure to press the dot (•) before

entering the subchannel number. press1, press 2, press the dot (•), press 3, then press OK.

C. Press GO BACK to return to the previously viewed channel.

What is the subchannel

By using high compression techknology, digital broadcasting offers a service that enables multiple

signals to sent simultaneously. Therefore, you can select more than one program per main channel

since digital broadcasting technology distinguish between multiple channels by a single network.

Turning your TV on or off

1. Plug the power cord into an AC power outlet.

2. Press

to turn on your TV.

3. Press

again to turn off your TV. When you turn off the TV, it goes into standby mode.

Warning: When your TV is in standby mode, it is still receiving power. To completely disconnect

power, unplug the power cord.

Selecting the video input source

1. Turn on your TV, then press INPUT on the remote. The

Input list opens.

2. To selelct an input source, press INPUT repeatedly, or

press

to highlight the video source, then press OK.

Note: HDMI 3 is not available for models L32HDF10/

L26HDF10.

Adjusting the Volume

This section describes how to adjust the volume. The mute function, which turns the sound off and on,

is also described.

A. use VOL+/- to adjust volume.

The volume bar will be displayed at the bottom of the TV screen when adjusting the volume.

• The volume bar will automatically disappear in a few seconds.

B. Press MUTE to turn off and on the sound.

Mute mark is diaplayed on the TV screen for a few seconds.

Press MUTE again or VOL +/- to recover the orignal volume.

Chapter 2 Understanding the basics

Input

VID

CMPT No Lable

HDMI1 No Lable

HDMI2 No Lable

No Lable

HDMI3 No Lable