User's Manual

when the machine plays in normal)
④ “▼”button(Press it to move the cursor down in the menu; Or to move down
the time and digit in the “Time And Date” item )
⑤ “MENU” button(Press it to enter or exit the setting menu)
⑥ “▲”button(Press it to move the cursor up in the menu; Or to move down the
time and digit in the “Time And Date” item)
⑦ “▶”button(Press it to move the cursor right in the menu; Or to increase
volume when the machine plays in normal)
Important:
① This remote control uses button battery, it installs i
n the bottom of the remote
control.
② Please aim the remote control at the reception window on the side of the
machine. If any barrier between them, the remote control may be out of order.
③ To insure good operation performance, if it is not sensitive, please replace the
battery immediately.
④ Once the battery electricity is cheap, the electrolyte leak will take place, which
will damage the remote control. Once it happens ,please replace the battery as
soon as possible.
⑤ If you do not use the remote control in a long time ,please take out the battery
In case it leaks electrolyte.`
Basic Operation
When opening the machine, you need to notice the following operation and
installation matters
1. connect to the power
Ple
ase insert the power outlet to the AC outlet, open the port door with key, and
then make sure the memory card has inserted to the card slot. Pull the
power-switch to “switch on” state and start the machine.
2. Power off Press the button on the remote control, you can set the machine
into standby mode, and the indicator light turns red. Pull the power switch to
“switch off” state, you can turn off the power.
3. Change volume
Press the direction button▶,◀, you can adjust the machine’s volume.
Notice: If you switch on/off the machine continuously, please confirm the
time-lag longer than 5 second, to avoid the memory card damage and data loss.
If you transfer the machine from high-temperature environment into
low-temperature environment, there may be frosting on the screen and surface
of machine ,but it does not affect the use ,and will recover after several minutes.
Menu Function
Main Menu
① Press the “MENU” button on the remote control ,and the
n press <>>>button in
turns to unlock. Move the cursor to the “OK” option, and press the “OK” button