Operation Manual

Instruction
Form：DP5-005 Revised：05 35
6.Parameter explanation
For parameter setting, refer to [Wireless maintenance tool instruction].
●Radio frequency
Interval of frequency setting among wireless VIM stations shall be at least 3MHz.
Example of wireless VIM ST
① Process for BodyNo write, Diag inspection (BodyNo is not deleted)
Process for Diag inspection (BodyNo write, BodyNo delete is not performed)
② Process for Diag inspection, BodyNo delete (BodyNo write is not performed)
* If setting (2), BodyNo write cannot be performed because ID of parameter write waiting mode is different
from Wireless VIM terminal.
This function is required when disconnection is confirmed after diag inspection by TVECSIII.
Wireless VIM station setting Purpose explanation
Initial mode Wireless frequency 2453MHz(Ch52) Same frequency as wireless
VIM is required.
Wireless ID 52
Inspection mode Wireless frequency 2459MHz (Ch58) Frequency setting for process
Wireless ID 58
Parameter writing
wait mode
Wireless frequency 2480MHz(Ch79) Same frequency as wireless
VIM terminal is required.
Wireless ID 0
Parameter writing
mode
Wireless frequency 2459MHz(Ch58) Frequency setting for process
Wireless ID 58
Wireless VIM station setting Purpose explanation
Initial mode Wireless frequency 2453MHz(Ch52) Same frequency as
wireless VIM is required.
Wireless ID 52
Inspection mode Wireless frequency 2465MHz (Ch64) Frequency settings for
process
Wireless ID 64
Parameter writing
waiting mode
Wireless frequency 2480MHz(Ch79) Same frequency as wireless
VIM is required.
Wireless ID 64 Same ID as inspection
mode is required.
Parameter writing
mode
Wireless frequency 2465MHz(Ch64) Frequency settings for
process
Wireless ID 64