Operation Manual

Instruction
Form：DP5-005 Revised：05 22
3.5 Preparation
① Confirm if the below switch of wireless ST for program write is [RUN] side.
② Install wireless antenna to communicate with wireless terminal and connect wireless antenna cable
to SMA jack on wireless ST.
③ Connect between wireless ST and TVECSIII by LAN cable.
Connect LAN cable into [ETHERNET] connector of wireless ST.
LAN cables can be used straight/crosses cables both.
④ Connect POE to wireless ST.
Connect POE into DC jack [DC IN] of wireless terminal, connect to AC plug and enter power
supply.
Set [RUN](Left)side.
RUN
PRG
RUN
COLLISION
RECEIVE/LINK
COM PORT
PRG
RF LINK
MODE
ANTENNA
ANTENNA 1
ANTENNA 2