User's Manual
Table Of Contents
- Front Cover
- Table of Contents
- Disclaimer
- 1 General description
- 2 Instructions for safe operation
- 3 Standards and guidelines
- 4 Standard compliance
- 5 Connectors and pins
- 6 Specification of inputs and outputs
- 6.1 Positive power supply (BAT+)
- 6.2 Negative power supply (BAT-)
- 6.3 Ignition on switch input (Terminal 15)
- 6.4 External Wake-up
- 6.5 Service Enable
- 6.6 100BASE-TX interface
- 6.7 100BASE-T1 interface
- 6.8 USB OTG interface
- 6.9 USB Host interface
- 6.10 RS-232 interface
- 6.11 CAN interface
- 6.12 Analog video input
- 6.13 Camera supply
- 7 Internal structure
- 8 Power modes
- 9 Device front
- 10 Connectors and cable specifications
- 11 References
- 12 Glossary
11. REFERENCES
≡
11 References
[1] Vision 312 Product Drawing, D-156-C-20-003. TTControl GmbH.
[2] Vision 312 Mounting Requirements Document, D-156-G-20-010. TTControl GmbH.
[3] ISO. ISO 11783-2:2012(E) (see section 11.1).
11.1 Referenced norms and standards
Documement
no.
Rev. Document title
ISO 16750-1 2006 Road vehicles — Environmental conditions and testing for electrical and
electronic equipment — Part 1: General
ISO 16750-2 2012 Road vehicles — Environmental conditions and testing for electrical and
electronic equipment — Part 2: Electrical loads
ISO 16750-3 2012 Road vehicles — Environmental conditions and testing for electrical and
electronic equipment — Part 3: Mechanical loads
ISO 16750-4 2010 Road vehicles — Environmental conditions and testing for electrical and
electronic equipment — Part 4: Climatic loads
ISO 16750-5 2010 Road vehicles — Environmental conditions and testing for electrical and
electronic equipment — Part 5: Chemical loads
CISPR 25 2016 Vehicles, boats and internal combustion engines — Radio disturbance
characteristics — Limits and methods of measurement for the protection
of on-board receivers
ECE R10
Rev.05
2014 Uniform provisions concerning the approval of vehicles with regard to elec-
tromagnetic compatibility
ISO 11452-1 2015 Road vehicles — Component test methods for electrical disturbances from
narrowband radiated electromagnetic energy — Part 1: General principles
and terminology
ISO 11452-2 2004 Road vehicles — Component test methods for electrical disturbances from
narrowband radiated electromagnetic energy — Part 2: Absorber-lined
shielded enclosure
ISO 11452-4
2011 Road vehicles — Component test methods for electrical disturbances from
narrowband radiated electromagnetic energy — Part 4: Harness excitation
methods
ISO 11452-5 2002 Road vehicles — Component test methods for electrical disturbances from
narrowband radiated electromagnetic energy — Part 5: Stripline
ISO 11783-2
2018 Tractors and machinery for agriculture and forestry — Serial control and
communications data network — Part 2: Physical layer
ISO 10605 2008 Road vehicles — Test methods for electrical disturbances from electro-
static discharge
ISO 7637-2 2011 Road vehicles — Electrical disturbances from conduction and coupling —
Part 2: Electrical transient conduction along supply lines only
© TTControl GmbH 2020. All rights reserved.
Confidential and Proprietary Information
42
Document Number:
D-156-G-02-001