User's Manual
Table Of Contents
- Front Cover
- Table of Contents
- Disclaimer
- 1 General description
- 2 Instructions for safe operation
- 3 Standards and guidelines
- 4 Standard compliance
- 5 Connectors and pins
- 6 Specification of inputs and outputs
- 6.1 Positive power supply (BAT+)
- 6.2 Negative power supply (BAT-)
- 6.3 Ignition on switch input (Terminal 15)
- 6.4 External Wake-up
- 6.5 Service Enable
- 6.6 100BASE-TX interface
- 6.7 100BASE-T1 interface
- 6.8 USB OTG interface
- 6.9 USB Host interface
- 6.10 RS-232 interface
- 6.11 CAN interface
- 6.12 Analog video input
- 6.13 Camera supply
- 7 Internal structure
- 8 Power modes
- 9 Device front
- 10 Connectors and cable specifications
- 11 References
- 12 Glossary
10. CONNECTORS AND CABLE SPECIFICATIONS
10.5 Cables
TTControl recommends the following cables for mating connectors:
Connector Function Article description Type
designation
Recommendation
C1 CAN Single twisted pair,
120 Ω, 2x0.35 mm
2
FLRY 2x35-A
H=20 GE/GR
Automotive standard
C1 Video
signals
Shielded video
cable (Coax type,
75 Ω impedance,
signal cable)
Lapp 2170010,
Helu 40010,
Medi 2270187
C1 all other
functions
0.75 mm
2
0.75 mm
2
Automotive standard
A 100BASE-T1
100BASE-TX
unshielded twisted pair
(-T1 with one pair)
(-TX with two pairs)
4x0.14
Cu SF/TQ.
RosenbergerHSD
LD5-105-xxxx-A-x
B, D USB OTG
USB Host
Standard USB cable 4x0.14
Cu SF/TQ
RosenbergerHSD
LD5-105-xxxx-F-x
C reserved for
future use
© TTControl GmbH 2020. All rights reserved.
Confidential and Proprietary Information
41
Document Number:
D-156-G-02-001