User's Manual
Table Of Contents
- Front Cover
- Table of Contents
- Disclaimer
- 1 General description
- 2 Instructions for safe operation
- 3 Standards and guidelines
- 4 Standard compliance
- 5 Connectors and pins
- 6 Specification of inputs and outputs
- 6.1 Positive power supply (BAT+)
- 6.2 Negative power supply (BAT-)
- 6.3 Ignition on switch input (Terminal 15)
- 6.4 External Wake-up
- 6.5 Service Enable
- 6.6 100BASE-TX interface
- 6.7 100BASE-T1 interface
- 6.8 USB OTG interface
- 6.9 USB Host interface
- 6.10 RS-232 interface
- 6.11 CAN interface
- 6.12 Analog video input
- 6.13 Camera supply
- 7 Internal structure
- 8 Power modes
- 9 Device front
- 10 Connectors and cable specifications
- 11 References
- 12 Glossary
8. POWER MODES
Power-off → Power-on 1 Wake-up event:
• rising edge on Terminal 15 signal
• rising edge on Wake-up signal
• reception of wake-up pattern on a wake-up enabled
CAN interface
• reception of wake-up pattern on a wake-up enabled
100BASE-T1 interface
• real-time clock with configured alarm-time and date
Power-on → Suspend At application request
Power-on → Disconnect 2 Terminal 30 disconnected from power supply
Suspend → Power-on Wake-up event:
• rising edge on Terminal 15 signal
• rising edge on Wake-up signal
• reception of wake-up pattern on a wake-up enabled
CAN interface
• reception of wake-up pattern on a wake-up enabled
100BASE-T1 interface
• real-time clock with configured alarm-time and date
• touch event
Suspend → Disconnect 2 Terminal 30 disconnected from power supply
Note 1 Ensure that the device remains disconnected for a minimum of one second when
switching the device off and on again (corresponds to power mode transistion: Power-
off → Disconnect → Power-on).
Note 2 Performing this mode transistion is not recommended as all unsaved data will be lost,
and all operations running will be terminated in an uncontrolled manner. Users are
advised to power-off by setting Terminal 15 to low, and waiting until the application
performs a controlled shut down of the device.
© TTControl GmbH 2020. All rights reserved.
Confidential and Proprietary Information
34
Document Number:
D-156-G-02-001