User's Manual
Table Of Contents
- Front Cover
- Table of Contents
- Disclaimer
- 1 General description
- 2 Instructions for safe operation
- 3 Standards and guidelines
- 4 Standard compliance
- 5 Connectors and pins
- 6 Specification of inputs and outputs
- 6.1 Positive power supply (BAT+)
- 6.2 Negative power supply (BAT-)
- 6.3 Ignition on switch input (Terminal 15)
- 6.4 External Wake-up
- 6.5 Service Enable
- 6.6 100BASE-TX interface
- 6.7 100BASE-T1 interface
- 6.8 USB OTG interface
- 6.9 USB Host interface
- 6.10 RS-232 interface
- 6.11 CAN interface
- 6.12 Analog video input
- 6.13 Camera supply
- 7 Internal structure
- 8 Power modes
- 9 Device front
- 10 Connectors and cable specifications
- 11 References
- 12 Glossary
5. CONNECTORS AND PINS
19 Camera 4 GND
13 bidirectional CAN 0 High bidirectional CAN 0 High
5 bidirectional CAN 0 Low bidirectional CAN 0 Low
12 bidirectional CAN 1 High bidirectional CAN 1 High
4 bidirectional CAN 1 Low bidirectional CAN 1 Low
11 bidirectional CAN 2 High
3 bidirectional CAN 2 Low
24 bidirectional CAN 3 High
32 bidirectional CAN 3 Low
25 out RS-232 TX out RS-232 TX
33 RS-232 GND RS-232 GND
34 in RS-232 RX in RS-232 RX
For more information on recommended connectors and wires to interface with a Vision 312 device, refer
to section 10.
5.3 100BASE-T1 and 100BASE-TX connector (A)
100BASE-T1 is supported by the Vision 312 products.
100BASE-TX is supported by the Vision 312Plus products.
The connector A is color-coded black.
Mates with: Rosenberger D4K14A-1D5A5-A
Figure 5: Connector A pinout
© TTControl GmbH 2020. All rights reserved.
Confidential and Proprietary Information
15
Document Number:
D-156-G-02-001