User's Manual
Table Of Contents
- Front Cover
- Table of Contents
- Disclaimer
- 1 General description
- 2 Instructions for safe operation
- 3 Standards and guidelines
- 4 Standard compliance
- 5 Connectors and pins
- 6 Specification of inputs and outputs
- 6.1 Positive power supply (BAT+)
- 6.2 Negative power supply (BAT-)
- 6.3 Ignition on switch input (Terminal 15)
- 6.4 External Wake-up
- 6.5 Service Enable
- 6.6 100BASE-TX interface
- 6.7 100BASE-T1 interface
- 6.8 USB OTG interface
- 6.9 USB Host interface
- 6.10 RS-232 interface
- 6.11 CAN interface
- 6.12 Analog video input
- 6.13 Camera supply
- 7 Internal structure
- 8 Power modes
- 9 Device front
- 10 Connectors and cable specifications
- 11 References
- 12 Glossary
5. CONNECTORS AND PINS
≡
5 Connectors and pins
Vision 312 is equipped with a 34-pin main connector and up to 4 HSD connectors. The main connector is
compatible with the TYCO Super Seal 1 mm series.
This section defines the pinouts of the connectors, while section 10 lists the mating connectors and their
manufacturer part numbers. The detailed description of signals is described in section 6.
5.1 Available connectors
Depending on whether the device is a Vision 312 or Vision 312Plus product, the device is equipped with
the Main Connector (C1) and the connectors A, B, C, and D — or a subset of them. Figure 3 shows the
backside of a Vision 312 device equipped with all connectors. Table 5 shows the available connectors for
the various products.
Figure 3: Vision 312Plus device with all connectors — backside view
The available connectors for the various Vision 312 family products are:
Products Connectors
C1 A B C D
Vision 312 Yes Yes Yes No No
Vision 312Plus Yes Yes Yes Yes Yes
Table 5: Supported connectors for the various Vision 312 family products
© TTControl GmbH 2020. All rights reserved.
Confidential and Proprietary Information
13
Document Number:
D-156-G-02-001