TURNTABLE PLAYER ECS01
READ INSTRUCTIONS CAREFULLY BEFORE USE AND STORE IN A SAFE PLACE FOR FUTURE REFERENCE FCC WARNING This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
DESCRIPTION CONTROL ELEMENTS
Turntable Operation 1. Ensure that the mains voltage of your home corresponds to the operating voltage of the adapter. Connect the power adapter to the wall outlet. Connect the DC connector to the “DC IN” jack on the rear of the unit. 2. Place the vinyl record on the big platter gently. 3. Set the correct speed of your vinyl record (33/45/RPM). For 45 RPM vinyl record, please use the 45RPM adaptor. 4. Turn on the power of the turntable. 5. Move the tonearm to the requested starting point on the record.
Play music with USB/SD and Bluetooth This function part allows user play music from inserted USB flash drive or SD card or Bluetooth or Aux in function. Insert USB flash drive or SD card in appropriate slot or connect your Bluetooth device. play previous music play next music on play mode: short press to start or pause the playing Bluetooth control When the tone arm set to the rest position, Bluetooth function will start automatically. Then need to press the mode key to circle between USB/SD and BT.
To fit a new cartridge, repeat process 3 & 4 in reverse order. Note: Please exercise extreme care whilst performing this operation so as to avoid damaging the tone arm and audio line wires. The Turntable’s cartridge needs to be replaced every 3 - 4 months (approximately every 250 hours of total playback time) after continuous playing. Replacement Ceramic type Cartridges are widely available to purchase from the internet.
FAQs Problem The unit will not power ON. There is no sound. The vinyl record will not play. Nothing will play via the AUX OUT connection. There is no sound via the Stereo RCA port. Solution Make sure the unit’s power cord is connected to an appropriate electrical outlet and the wall socket is switched ON. Rotate the POWER/VOLUME knob clockwise to increase the volume. Make sure you have selected the correct speed (33 1/3, 45 or 78 RPM). Make sure the power adapter is correctly plugged in.
