Product Guide

20
The Spray Booth
How many spray booths are there? __________
What type of booths do you have? _____Downdraft _____Cross Flow _____Semi Downdraft
How many spray drops in each booth? __________
What is the humidity reading in the booth(s)? __________%RH __________%RH __________%RH
Is there air preparation at the booth? (filters or dryers) _____Y _____N
If yes, what brand or type? (ex: SATA, DeVilbiss, Sharpe, Camair, RTI, etc.) ___________________
Is the shop spraying waterborne paint? _____Y _____N
If yes, how are you drying the basecoats? ____Booth Fans ____Handheld Blowers/Stands ____other
If other, what is being used? ____________________
Does the shop do mostly collision work or completes? ____________________
The Prep Station
How many prep stations? __________
Do you spray in them? _____Y _____N
Is there air preparation at the booth? (filters or dryers) _____Y _____N
If yes, what brand or type? (ex: SATA, DeVilbiss, Sharpe, CamAir, RTI, etc.) ___________________
What is the humidity reading in the prep station? __________%RH __________%RH __________%RH
The Paint Shop
How many painters will be using the air system? _______
How many shop employees total will be using the air system? _______
Is the air system a looped system or a “dead end”/”dead stick system”? ____________________
What is the approximate distance from the compressor to the booth? __________Ft. (_____paces)
What is the approximate line size of the main air line? __________
What is the approximate line size of the supply air lines used in shop? ________
Are there air leaks in the piping, at air fittings, or air hoses? _____Y _____N
What material is the piping made from? _____Copper _____Black Iron ______Galvanized _____PVC
(Tsunami Compressed Air Solutions™ does not recommend PVC or other plastic piping)
Shop Analysis Questionnaire
The Compressor Room
How many compressors do you have? ________
What is the horsepower of each compressor? (Look at electric motor plate) ______________Hp
Manufacturer? ___________________________ Model # ________________________________
Is your compressor used for the whole shop? _____Y _____N
If no, what is the Hp of the compressor for the paint shop? _____________Hp
What is the air system pressure? (look at compressor tank gauge) _________PSI
Does the compressor tank have an automatic drain? _____Y _____N
Is the drain working? _____Y _____N
If no, repair or replace.
Where is the compressor located? (in a closed room, outside, on a mezzanine, etc.) _____________________
Is there a pressure regulator located at or near the compressor for the whole system? _____Y _____N
If yes, what pressure is it set at? (look at pressure gauge) _______PSI
Is the compressor room ventilated? _____Y _____N
Does the receiver tank of the compressor feel warm to the touch? _____Y _____N
Is there a refrigerated dryer? _____Y _____N
If yes, is it working? _____Y _____N
(This can be determined by grasping the inlet air line and the outlet air line with your hand, one should be
warm and the other should be cool. If there is no difference, it probably is not working.)
If there is no refrigerated dryer, is there another type of drying technology being used? _____Y _____N
If yes, what type? _______________________________
Does the drying technology (refrigerated or other) have pre-filters installed before the unit? _____Y _____N
Tsunami Compressed Air Solutions™ is a division of