SDS

LN-950 POLYURETHANE AHE95012TN0
Product name
5
Product code
Date of issue
Version
00407720
17 August 2015
Section 7. Handling and storage
Advice on general
occupational hygiene
Conditions for safe storage,
including any
incompatibilities
Eating, drinking and smoking should be prohibited in areas where this material is
handled, stored and processed. Workers should wash hands and face before eating,
drinking and smoking. Remove contaminated clothing and protective equipment before
entering eating areas. See also Section 8 for additional information on hygiene
measures.
Do not store above the following temperature: 35°C (95°F). Store in accordance with
local regulations. Store in a segregated and approved area. Store in original container
protected from direct sunlight in a dry, cool and well-ventilated area, away from
incompatible materials (see Section 10) and food and drink. Eliminate all ignition
sources. Separate from oxidizing materials. Keep container tightly closed and sealed
until ready for use. Containers that have been opened must be carefully resealed and
kept upright to prevent leakage. Do not store in unlabeled containers. Use appropriate
containment to avoid environmental contamination.
:
:
Protective measures
Put on appropriate personal protective equipment (see Section 8). Persons with a
history of skin sensitization problems or asthma, allergies or chronic or recurrent
respiratory disease should not be employed in any process in which this product is used.
Avoid exposure - obtain special instructions before use. Do not handle until all safety
precautions have been read and understood. Do not get in eyes or on skin or clothing.
Do not breathe vapor or mist. Do not ingest. Use only with adequate ventilation. Wear
appropriate respirator when ventilation is inadequate. Do not enter storage areas and
confined spaces unless adequately ventilated. Keep in the original container or an
approved alternative made from a compatible material, kept tightly closed when not in
use. Store and use away from heat, sparks, open flame or any other ignition source.
Use explosion-proof electrical (ventilating, lighting and material handling) equipment.
Use only non-sparking tools. Take precautionary measures against electrostatic
discharges. Empty containers retain product residue and can be hazardous. Do not
reuse container.
:
Precautions for safe handling
Special precautions
:
Vapors may accumulate in low or confined areas or travel a considerable distance to a
source of ignition and flash back. Vapors are heavier than air and may spread along
floors. If this material is part of a multiple component system, read the Safety Data
Sheet(s) for the other component or components before blending as the resulting
mixture may have the hazards of all of its parts.
Precautions should be taken to minimize exposure to atmospheric humidity or water.
CO₂
will be formed, which, in closed containers, could result in pressurization.
Limestone
OSHA PEL (United States, 2/2013).
TWA: 5 mg/m³ 8 hours. Form: Respirable
fraction
TWA: 15 mg/m³ 8 hours. Form: Total dust
Stoddard solvent
ACGIH TLV (United States, 4/2014).
TWA: 525 mg/m³ 8 hours.
TWA: 100 ppm 8 hours.
OSHA PEL (United States, 2/2013).
Section 8. Exposure controls/personal protection
Ingredient name
Exposure limits
Control parameters
Occupational exposure limits
United States
Page: 6/14