SDS

LN-950 POLYURETHANE AHE95012TN0
Product name
9
Product code
Date of issue
Version
00407720
27 February 2017
Section 6. Accidental release measures
Stop leak if without risk. Move containers from spill area. Use spark-proof tools and
explosion-proof equipment. Approach release from upwind. Prevent entry into sewers,
water courses, basements or confined areas. Wash spillages into an effluent treatment
plant or proceed as follows. Contain and collect spillage with non-combustible,
absorbent material e.g. sand, earth, vermiculite or diatomaceous earth and place in
container for disposal according to local regulations (see Section 13). Dispose of via a
licensed waste disposal contractor. Contaminated absorbent material may pose the
same hazard as the spilled product. Note: see Section 1 for emergency contact
information and Section 13 for waste disposal.
Large spill
:
Stop leak if without risk. Move containers from spill area. Use spark-proof tools and
explosion-proof equipment. Dilute with water and mop up if water-soluble. Alternatively,
or if water-insoluble, absorb with an inert dry material and place in an appropriate waste
disposal container. Dispose of via a licensed waste disposal contractor.
Small spill
:
Section 7. Handling and storage
Advice on general
occupational hygiene
Conditions for safe storage,
including any
incompatibilities
Eating, drinking and smoking should be prohibited in areas where this material is
handled, stored and processed. Workers should wash hands and face before eating,
drinking and smoking. Remove contaminated clothing and protective equipment before
entering eating areas. See also Section 8 for additional information on hygiene
measures.
Do not store above the following temperature: 35°C (95°F). Store in accordance with
local regulations. Store in a segregated and approved area. Store in original container
protected from direct sunlight in a dry, cool and well-ventilated area, away from
incompatible materials (see Section 10) and food and drink. Eliminate all ignition
sources. Separate from oxidizing materials. Keep container tightly closed and sealed
until ready for use. Containers that have been opened must be carefully resealed and
kept upright to prevent leakage. Do not store in unlabeled containers. Use appropriate
containment to avoid environmental contamination.
:
:
Protective measures
Put on appropriate personal protective equipment (see Section 8). Avoid exposure -
obtain special instructions before use. Do not handle until all safety precautions have
been read and understood. Do not get in eyes or on skin or clothing. Do not breathe
vapor or mist. Do not ingest. Use only with adequate ventilation. Wear appropriate
respirator when ventilation is inadequate. Do not enter storage areas and confined
spaces unless adequately ventilated. Keep in the original container or an approved
alternative made from a compatible material, kept tightly closed when not in use. Store
and use away from heat, sparks, open flame or any other ignition source. Use
explosion-proof electrical (ventilating, lighting and material handling) equipment. Use
only non-sparking tools. Take precautionary measures against electrostatic discharges.
Empty containers retain product residue and can be hazardous. Do not reuse container.
:
Precautions for safe handling
Special precautions
:
Vapors may accumulate in low or confined areas or travel a considerable distance to a
source of ignition and flash back. Vapors are heavier than air and may spread along
floors. If this material is part of a multiple component system, read the Safety Data
Sheet(s) for the other component or components before blending as the resulting
mixture may have the hazards of all of its parts.
United States
Page: 5/14