User's Manual

INSERTING A PICTURE

NOTE: If the photo/picture size does not fit the frame, you can use the transparent

frame to trace the frame size and cut the photo/picture with scissors.

The transmitter is designed to operate on AC household current only. The receivers are

designed to operate on AC household current or DC (batteries).

AC OPERATION

TRANSMITTER

To operate the unit using AC power, connect

an AC adapter (included) to an AC outlet hav-

ing 120V, 60Hz AC only. Plug the small end

into the DC 6V jack on the rear of the unit and

connect the other end into the AC outlet.

RECEIVER

To operate the unit using AC power, connect

an AC adapter (included) to an AC outlet hav-

ing 120V, 60Hz AC only. Plug the small end into the DC 6V jack ON THE SIDE OF THE

CRADLE and connect the other end into the AC outlet. Place the Receiver onto the

Receiver’s cradle and make sure the metal contact plates on the Receiver are proper-

ly in contact with the metal contact pins on the Receiver’s cradle. The batteries are

automatically disconnected when the AC adapter is used.

CAUTION: Use only the supplied AC adapter(s) for AC operation. When not using AC

power, disconnect the AC adapter from the wall outlet by pulling the plug (not the cord).

Do not touch the AC adapter with wet hands. Fully insert the plug without exposing any

part of the blade. SPECS: DC6V

IMPORTANT: If the unit is has no power, or if the monitor is on a different channel than

the transmitter, the red SOUND LEVEL indicators will not light up. Please ensure at

least one red light is lit to indicate the unit is operating properly.

PREPARATION

Press in on the two Frame Tabs and

slightly lift the transparent frame out.

Insert a picture, then replace the

transparent frame, by positioning the

two tabs at the bottom of the frame, and

insert properly into the unit.