GRS Push & Pull Spinner V2 User manual TS-DOT-02 2022/08/12
What is included? GRS Push & Pull Spinner V2 (TS-DOT-02) 1. GRS Push & Pull Spinner (Model Name: TS-DOT-02) X 1 2. Gold leaf arcade buttons X 2 3. Push button IO conversion board X 1 4. Wiring harness for scroll up and scroll down buttons X 1 5. Wiring harness for push button IO functionality X 1 6.
How to hook up the spinner with push buttons for mouse scrolls? 1. Use the wiring harness for scroll up and scroll down buttons 2. Make sure the button output mode is “Disable” 3. Connect the wiring harness for scroll buttons JST side to the spinner P1 3. Hook up the green (Signal) wire and black (GND) wire for scroll down button Spinner JST Connector Continue to next page…..
How to hook up the spinner with push buttons for mouse scrolls? 4. Hook up the blue (Signal) wire and black (GND) wire for scroll up button 6. Now hook up the USB cable JST side to the spinner P2 5. You should see something like this if everything has been connected correctly 7.
How to enable push & pull to function as standard button output? 1. Make sure the button output mode is “Enabled” 2. Connect the USB wiring harness JST side with the conversion board 3. Connect Wiring harness for push button larger JST side with the other side of the conversion board Spinner JST Connector Continue to next page…..
How to enable push & pull to function as standard button output? 4. Now hook up the wiring harness for push button IO larger JST connector with P2 on the spinner 6. Setup is completed you can now connect these two JST 2.54 connector for push and pull button with your external encoder board PULL GND PUSH 5. Hook up the smaller connector from wiring harness for push button with P1 on the spinner 7.
GRS Spinner Configuration Tool - User Guide (For TS-DOT-02 and TS-BSP-02 and above version only) 2022/05/7
Features of GRS Spinner Configuration Tool • Configurability for spinner cursor movement between X and Y Axis • Configurable resolution between 3 different preset CPIs: 360, 720, and 1440 • Ability to append an ID to the spinner driver's name • Ability to enable push and pull function as a standard button IO signal • TS-DOT-02 or above "Push" and "Pull" button calibration • Download here
GRS Spinner Configuration Tool (For TS-DOT-02 and TS-BSP-02 and above version only) Spinner model name and firmware version Select between X and Y axis for cursor movement. Click apply to save change TS-DOT-02 push & pull button calibration. Click apply to save change Change the spinner resolution between 360, 720, and 1440 CPI. Click apply to save change Enable/Disable TSDOT-02 push & pull to function as a conventional push button.
